Love it!!!! This one is definitely a keeper. I would tell everyone to get one. The pro or even the bum trying to brew in his garage. You need this

This is an excellent regulator and easy to adjust pressure. Although it is heavy: when your gas bottle starts to lighten up, the heavy regulator will tip it over, so you need to support it or lean it so it doesn't tip the whole schmere over.

Allows control of two kegs with different beers

So far I am quite happy with this item. I attached a line to one and set it at 30 PSI to force charge the new keg and attached a 4-way splitter to the other and set it around ten PSI to dispense.

this is a great regulator I couldn't be happier..

Takes a little bit to figure it out if you are changing out regulators. But other then that it is good.

It is great just what I wanted

Makes it easy to set one keg to burst carb and another at serving pressure. Easy to set levels as well. Be careful with how top heavy this unit can be because it will fall down, especially when the tank gets low. I unfortunately busted my fill gauge but it does still work.

The regulator has been working well for about two weeks. No problems it is easy to set pressure and it holds pressure

Quick shipping great regulator love the tank pressure gauge. I now know what is left in the tank.

Simple set up with easy to read dials.

No compaints! Well built and looks professional.

I ordered this regulator to replace an old regulator that won't hold pressure constantly. I have a single taprite, but need a dual valve version. This unit is great and precise. 11 psi means 11 psi. I highly recommend these regulators, don't get the cheap ones you will likely regret it and end up with one of these later on.

I like the dual guages allowing me.to set different pressures for two kegs.

Easy to read dials, large adjustment knobs & shut-off valves. Works really well to have 2 different pressures on 2 each keg.

If you don't have this gauge set you should. Especially for the homebrewer. Nice to have the ability to run two seperate pressures. This comes in handy for carbonating and serving two different types of beer at one time. No problems this far. Would recommend to anyone.

Slightly top heavy on the co2 bottle but controls top two legs are flawless and easy to change pressure

Great regulator with exact settings and control.

This regulator works great. No need to have the nylon gasket to seal it to the co2 bottle which makes it effortless to exchange tanks and eliminates the worry of leaks in your system.

I've had it hooked up now with two kegs and it has worked like a charm.

Now I can carbonate my Belgians to 19-20 psi at 45F while using the other gauge at 9 psi for serving.

No leaks, nice build quality. Very nice to have when you have a couple of beers that you want to carbonate at different levels.

I have this on my 2 tap system along with a distributor which allows me to have two kegs dispensing at the same pressure while I force carbonate another keg. To me, it is a really nice to have.

great set of regulators. I can force carb two different beers. downside, easy to tip CO2 bottle with these.

The only frustration I've had is that even when I only have one keg connected, my CO2 runs quicker than when I've attached a single body. Thankfully I've got one kicking around to plug on when I've only got one keg in the fridge. Otherwise, does great at carbonating and pouring 2 kegs at the same time.

Bought this to replace my old regulator that had persisted in leaking after a rebuild. I much prefer the design on this model - large knobs make it easy to set-and-forget the pressure. It is significantly lighter than my old model as well (though still solidly built).Recommend.

I purchased this to have two gas pressure settings for my beers: higher for forced carbonation of my kegs, and lower for serving. Does the job very well and I've had no issues (no leaks, etc.) whatsoever with the product.

Bought this for my Keezer setup. Have had zero problems with it so far.Good company name. Fair price.