Would have been 5-stars, but for the high cost. So tale of caution: I dropped my pump and the nipple on the head broke off. It was not a big fall, but there were SS Quick Connect Fittings and their weight involved that proved too much for the plastic nipple. So I ordered the Poly Pump Head. However, I should have removed the broken head before ordering a new one. These are magnetic driven and the magnet broke too. For the cost of the pump head, I could have replaced it with a new pump. (Not the same pump, but this one is over kill for my purposes.) Anyway, the replacement pump head works fine and the pump is working with a broken magnet! (All the pieces fit back easy enough. So before ordering - inspect the pump!

Excellent item, fits great with no issues.

As described. Perfect fit. Fast delivery

Accidentally dropped my current pump and cracked the head. Quick easy replacement and back to brewing.

Fit Perfectly. To all you brewers...while changing it out, there's your time to clean all the parts up.You will need to pull the spindle out of the old head, don't scratch it! push back in by hand or gently in vise.Cheers

Only issue is that the impeller shaft was really stuck in the old pump head and I was concerned about marring the shaft by pulling on it with pliers. I figured if I scratched up the shaft that the impeller may not seal properly on the shaft. Since the old pump head was damaged, I decided to drill a hole on the exterior of the head. You can actually see where the hole is from the mold they use. I drilled a hole and used a punch to knock out the shaft. Voila. It worked like a charm. Saves a lot of money buying the head replacement vs. the whole pump head assembly.

Having the pump head allowed me to quickly replace the part rather that the whole pump. I don't like to waist or to spend unnecessarily and this allowed me to do that.

I dropped my pump when attaching to my 3-tier frame. I thought I would need a whole new pump, but was pleasantly surprised to find this item was all I needed to repair and get back to brewing.

When I kicked my pump over in the middle of a brew session, I had to run down to More Beer for a replacement. Fortunately they had one and I was back up and running within minutes.

I use the metal quick disconnects on my pump. The neighbor kid stepped on them and broke the threaded end off. It took less than 2 minutes to put the new pump head on. 4 screws and a gasket, boom just like new again.